Tech Source Raptor X11R6.1 for AIX - Manual (Page 25)

Chapter 4 - Invoking X11R6.1
4-9
4.6 Common Desktop Environment (CDE)
Common Desktop Environment (CDE) is available with AIX and is
independent of the Raptor software. In order to use CDE, you need
to configure only
/usr/dt/config/Xservers
file. The example
below shows how to modify
Xservers
file to start CDE on Raptor
2100T.
:0 local /usr/x11R6.1/bin/Xtsi –Pll rap2kt0 :0
CDE can be started by typing:
prompt# /usr/dt/bin/dtlogin
4.6.1 MOX Mode Using CDE
In order to enable MOX when using CDE, you must make use of
the
StartWin
script installed in
/usr/X11R6.1/etc
. The
Xservers
file should be modified as follows:
:0 local /usr/X11R6.1/bin/StartWin:0
Additional command line options can be appended at the end of
this line. The following example
StartWin
script will start up the
X Server in mox24 mode.
#!/bin/sh
STARSMODE=+mox24
export
STARSMODE
pass=“/usr/X11R6.1/bin/Xtsi”$*
exec
$pass
NOTE: By default, the
StartWin
script starts up the X Server in
mox24 mode. It can be edited in order to support other MOX
modes.