Teletronics TT 2400 - Manual (Page 35)

Wireless On/Off
The on/off switch of the radio card.
Wireless Network Name (SSID)
Network Name is also known as SSID, which stands for Service Set Identifier. This is where you’re going to setup the
Service Set Identifier name for this AP. Remember that the SSID is cap sensitive just like that of a password.
Visibility Status
This controls the SSID broadcasting function. If enabled the SSID will be broadcasted out to all the wireless clients in
the area. If disabled the wireless clients will not be able to pickup the SSID but must explicitly know the SSID of the
unit in order to associate. The recommended practice is to set the visibility to invisible after setting up the wireless
network.
Transmission rate (Mbits/s)
This option indicates the transmission rate of the bridge. Specify the rate according to the speed of your wireless
network from the list. Most of the time the default setting Best (automatic) should be selected for best performance.
You may want to adjust the setting manually If your link quality and signal strength is usually low or high to get the best
performance.
802.11 Mode
Wireless mode allows the user to select whether this Bridge will connect to an 802.11b only network, an 802.11g only
network, an 802.11a only network or both b/g networks. If you only have b or g wireless devices on the network
selecting 802.11b or 802.11g only network will provide better performance then in mixed mode.
Adaptive Radio Selection
This is an option only if you’re using the dynamic turbo mode with an compatible Atheros radio chipset.
Super Mode
Super Mode is only supported if both the client and the AP is using compatible Atheros radio chipsets.

Disabled

Super A/G without Turbo

Super A/G with Static Turbo

Super A/G with Dynamic Turbo (AR enabled)
Auto Channel Select
Check this box to enable Access Point to automatically select the best channel at start up. This may take upto 20
seconds and no clients will be able to associate during this period.
RF Transmit Power
This section controls the power output for the mini-PCI radio card. The valid input range for this section is in the range
of 0-30 in dBm units. The default value is 23 dBm or 200mW.