Teo NT1-296 Rack - Manual (Page 2)

Tone Commander NT1-296 Rack / NT1U-223TC Installation Instructions
Page 2 13-102848 Rev. G
Important Safety Instructions
• This equipment is intended for installation in a restricted access location (dedicated equipment
rooms, equipment closets, or the like) in accordance with Articles 110-16, 110-17, and 110-18
of the National Electrical Code, ANSI/NFPA No. 70.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations
• Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying telephone wires.
• Do not mount the NT1-296 Rack within 12” of a heat source.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
Rack Mounting
1. The NT1-296 Rack can be mounted in an EIA standard 19” commercial or 23” telco rack.
2. Attach the mounting brackets to the rack in a 19” or 23” mounting position as needed, using the
supplied mounting bracket screws.
3. Mount the NT1-296 to the 19” or 23” rack standards using suitable fasteners.
Bracket Positions – 19” Rack Bracket Positions – 23” Rack
Power Supply
Attach ribbon cable connectors to the back panel before mounting the power supply (refer to page 5).
1. Plug the power output cable (red and black wires) into the POWER connector on the rack back panel.
2. Insert the tabs on the top edge of the power supply into the slots on the top panel of the NT1-296 as
shown below.
3. Pivot the power supply down until the lower tabs lock into the slots on the rack back panel. You may
need to lift the power supply slightly to insert the lower tabs into the rack. Make sure the power cable
is not pinched.
• To remove the power supply, lift up, then pull back on the power supply to disengage the lower tabs.
Rack Mount Power Supply Installation