Verilink Productivity 500 (34-00236) Product Manual - Manual (Page 88)

Page 88 500 TA Appendix B
When ordering with the ISDN ordering codes, use the ISDN Line Configura-
tion REQUEST FORM #1. If it is not convenient to deliver the form to your
service provider, you can call your provider with the information using the
form as a guide. Indicate the ordering code you wish to have configured and
the ISDN service provider will return the information necessary to configure
your 500 TA.
NOTE: When using the ISDN ordering codes method you will need to config-
ure your 500 TA switch type to National ISDN-1. Refer to the Network Setup
section (Chapter 3).
Ordering ISDN Using Alternate Method
If your service provider does not support the ISDN ordering codes method
of ordering then you must specify the configuration of your line. To help
you, TxPORT has provided a form specifying the required options for the
service provider. This information is found in the ISDN Line Configuration
REQUEST FORM #2. Follow the instructions below to order your service.
• Fill out the Consumer Information on pages one and two.
• Fax, or in some other way deliver, all four pages of the request form to your
ISDN service provider.
• Use the information returned to you by your service provider to configure
your 500 TA.
• After the 500 TA is configured, you must save the configuration and re-start
the 500 TA before the setup will take effect. See the Installation section
(Chapter 2) for details.
• You are now ready to use your ISDN service.