Extron electronic Low Profile Floor-Mount Raceway System for A/V Connectivity AVTrac - Manual (Page 14)

Installation
AVTrac • Installation 12
Step 3: AC Power Module
By this point, the connectivity box must be securely fastened to the floor.
If the AVTrac system does not include the AC power module, ignore this section. To attach the AC power module,
follow these instructions:
3-1 The AC power module must be positioned under the
triple AAP socket that is closest to the track. Seat the
power module on the stud in the connectivity box.
Slide the power module side tabs into the slots on
the side of the connectivity box.
Secure the module to the stud on the connectivity
box by hand tightening the provided 6/32" nut.
Attach AC power module
Slots
Studs
AC Power
Module
Tabs
3-2 Run the unattached end of the AC conduit through
the wall cutout and connect it to a junction box
inside the wall or ceiling.
Extron recommends the circuit be attached to a
junction box that is directly wired to the main circuit.
The AC power module does not have a fuse and is rated at
15 A, maximum.
Run AC conduit through wall cutout
W Switch off all electrical power before connecting the
AC conduit to a junction box, and keep power off until
installation is complete.
Conduit
Junction Box
Green
(ground)
AC Conduit
From AVTrack AC
Power Module
To 15 Amp
Main Circuit
White
(neutral)
Black
(hot)
Connect AC conduit to Junction Box
C All electrical installation should be performed by
qualified personnel in accordance with local and national
electrical codes.