Westermo PMI-110-F2G - Manual (Page 24)

3.2 Preparation for Web Interface
PMI Managed PoE Switch provides HTTP Web Interface and Secured HTTPS
Web Interface for web management
.
3.2.1 Web Interface
Westermo web management page is developed by JAVA. It allows you to use a
standard web‐browser such as Microsoft Internet Explorer, or Mozilla, to
configure and interrogate the switch from anywhere on the network.
Before you attempt to use the embedded web interface to manage switch
operation, verify that your PMI Managed PoE Switch is properly installed on
your network and that every PC on this network can access the switch via the
web browser.
1. Verify that your network interface card (NIC) is operational, and that your
operating system supports TCP/IP protocol.
2. Wire DC power to the switch and connect your switch to your computer.
3. Make sure that the switch default IP address is 192.168.2.200.
4. Change your computer IP address to 192.168.2.2 or other IP address which
is located in the 192.168.2.x (Network Mask: 255.255.255.0) subnet.
5. Switch to DOS command mode and ping 192.168.2.200 to verify a normal
response time.
Launch the web browser and Login.
6. Launch the web browser (Internet Explorer or Mozilla Firefox) on the PC.
7. Type http://192.168.2.200 (or the IP address of the switch). And then press
Enter.
8. The login screen will appear next.
9. Key in user name and the password. Default user name is admin and
password westermo.
Click on Enter or OK. The Welcome page of the web‐based management
interface will then appear.
20