Westermo RM-80 - Manual (Page 40)

40 6193-4201
Network A Configuration
In this example, network A is connected to the internet via a router at IP address
192.168.0.1.
Devices on Network A that only require access to devices on Networks A and B, should
have their gateway IP address set to the RM-80 Access Point as 192.168.0.200.
Devices on Network A, that must interact with devices on Networks A and B and the
internet should set the internet router 192.168.0.1 as their gateway, and must have a
routing rule established for devices on Network B. On PCs, this may be achieved with
the MS-DOS command ROUTE. For this example use: ROUTE ADD 192.168.102.0
MASK 255.255.255.0 192.168.0.200
Network B Configuration
All devices on Network B should be configured so their gateway IP address is that of the
RM-80 Access Point as 192.168.102.54
Access Point Configuration
… Connect straight through Ethernet cable between PC and RM-80.
… Ensure configuration PC and RM-80 are setup to communicate on the same network
… Set dipswitch to SETUP
… Power up unit, and wait for LINK led to cease flashing.
… Adjust PC network settings
Set Configuration PC network card with network setting of IP address 192.168.0.1,
netmask 255.255.255.0
… Open configuration webpage with Internet Explorer at address http://192.168.0.1XX/
When prompted for password, enter default username “user” and password “user”
Enter “Quick Start”, and select Access Point.
Change the IP address to 192.168.0.200
Enter a System Generator String
Select the Radio Encryption required.
Set dipswitch to RUN.
Save the changes, and unit will reset. Wait for unit to complete reset.
… Open configuration webpage with Internet Explorer at address http://192.168.0.200/
Select Network settings menu option
When prompted for password, enter default username “user” and password “user”
Device Mode should be set to Router.
Set the Gateway IP address to 192.168.0.1
Set the Ethernet IP address to 192.168.0.200, network mask 255.255.255.0
Set the Wireless IP address to 169.254.102.54, network mask 255.255.255.0
Click on button Save to Flash and Reset. Webpage will display that message indicating
details are being written to flash. Wait for RM-80 to reboot before removing power.