Westermo TF-300 - Manual (Page 14)

14 6606-2201
Xn Ð Result Codes Response Set:
This command selects which subset of the result messages that will be used by the
modem to inform the DTE of the results of the commands.
X0 Basic response set. Send only result codes OK, CONNECT, RING,
NO CARRIER, ERROR and NO ANSWER to DTE.
X1 Extended response set. Send result codes as above and also NO DIALTONE,
BUSY and NO ANSWER to DTE (default).
Z Ð Soft reset and Restore Profile
This command performs a soft reset and restores the stored profile.
&Zn=x Ð Store numbers and answerback
This command stores a string x which specifies the address for dialing with data/RTS,
the expected answerback or the stored answerback.
&Z0=... Number for dialling with data/RTS
&Z1=... Store answerback string in modem. This string will be sent when answerback
is active. Observe that only ASCII characters 33 up to 126 are possible to use
in the string.
&Z2=... Expected answerback string. This string will be searched for in a connection
when answerback mode is active. Observe that only ASCII characters 33 up to
126 are possible to use in the string.