Acti camerago! user manual – ACTi Camera Go! V1.5.10 User Manual
Page 10
ACTi CameraGo! User Manual
CameraGo! and B2-Frame will be disabled in camera
’s firmware. This way CameraGo! is able
to handle the incoming video stream without consuming too much computing resources of the
mobile device. After logging out from CameraGo!, these settings will be restored as they were
before.
As shown on Fig. 10, the user has four options to click:
1. Change the preset account name and password for CameraGo! that is used to access
cameras by pressing
if necessary. The account name and the password for
CameraGo! have to be the same as in the camera that is connected to PMON-1001 via
Ethernet cable.
2. The
“New Search” button is used when another camera is connected to PMON-1001 with
possibly different name and IP address. It is usually used when there are several cameras
to be installed on the site, one after another.
3. The
“OK” button is used to access the Live View page to proceed with camera viewing
angle and focus adjustment.
4. By clicking on the icon or the symbol it is possible to check the version of
CameraGo!
Fig. 11 Check the version of CameraGo!
If you are working with the cameras that have account name
and password other
than default, then you need to set that information to CameraGo!, too. Click to access the
settings page of account name and password and make changes there.