Equator BCR 500 - Manual (Page 7)

7
INSTALLATION INSTRUCTIONS
Ø Before Using Your Beer Cooler
· Remove the exterior and interior packing.
· Check to be sure you have all of the following parts:
· Instruction manual
· 1 Safety Guard Rail
· 1 Drip Tray (2 Pieces)
· 1 CO
2
Cylinder Support
· 1 CO
2
Regulator (Box)
· 1 CO
2
Empty Cylinder(Box)
· 1 CO
2
Air Line Hose (Red)
· 1 Beer Keg Coupler (Box)
· 1 Beer Tower
· 1 Pull Handle (Beer Tower Faucet)
· 1 metal wrench
· 4 Plugs: For Guard Rail Holes
· 1 Metal Plate For Cabinet Bottom
· 2 Steel wire shelves
· 1 Steel Clamp for Red Hose
· 4 Casters with lock
· Before connecting the Beer Cooler to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
· Clean the interior surface with lukewarm water using a soft cloth.
Ø Installing Your Beer Cooler
· This appliance is designed to be free standing only, and should not be recessed or built-in.
· Place your Beer Cooler on a floor that is strong enough to support the Beer Cooler when it is
fully loaded.
· Allow 3 inches of space between the back and sides of the Beer Cooler, which allows the
proper air circulation to cool the compressor.
· Locate the Beer Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the Beer Cooler not to
perform properly.
This unit is not designed for outside installation (ie garages, porches etc.)
· Avoid locating the Beer Cooler in moist areas.
· Plug the Beer Cooler into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized service center.
· After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing any contents in the Beer Cooler compartment.