Equator BCR 500 - Manual (Page 8)

8
Ø Electrical Connection
This Beer Cooler should be properly grounded for your safety. The power cord of this Beer Cooler is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
Use of extension cords is not recommended.
This Beer Cooler requires a standard 115/120-volt, 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the Beer Cooler and not left exposed or dangling to prevent
accidental injury.
Never unplug the Beer Cooler by pulling the power cord. Always grip the plug firmly and pull straight
out from the receptacle.
Warning
CO
2
GAS CAN BE DANGEROUS
WARNING: CO
2
cylinders contain high-pressure compressed gas which can be hazardous if not
handled properly. Make sure you READ and UNDERSTAND the following procedures for CO
2
cylinders BEFORE INSTALLATION.
1. ALWAYS connect the CO
2
cylinder to a regulator. Failure to do so could result in explosion
with possible injury when the cylinder valve is opened.
2. NEVER connect the CO
2
cylinder directly to the product container.
3. ALWAYS follow correct procedures when cylinders are changed.
4. ALWAYS secure the cylinder in an upright position.
5. NEVER drop or throw a CO
2
cylinder.
6. ALWAYS keep a CO
2
cylinder away from heat. Store extra cylinders in a cool place
(preferably 70°F). Securely fasten with a chain in an upright position when storing.
7. ALWAYS ventilate and leave the area immediately if CO
2
leakage has occurred.
8. ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over five (5)
years, do not use, return cylinder to gas supplier.
9. NEVER connect a product container unless there are two (2) safety’s in the pressure system:
a. One at or on the CO
2
regulator
b. One at or on the product coupler or in the pressure gas line.
~
Warning
~
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.