Installation, cont’d, Rear panel and side panel connections, Mkp 2000 remote control panel • installation – Extron electronic MKP 2000 User Manual

Page 11: Figure 2-5 — mounting the mkp to the wall box, Figure 2-6 — mkp rear and side panels

Advertising
background image

MKP 2000 Remote Control Panel • Installation

MKP 2000 Remote Control Panel • Installation

Installation, cont’d

3

.

Mount the MKP’s faceplate to the mud ring or wall box
with machine screws (figure 2-5).

MK

P 200

0

4

5

6

1

2

3

7

8

9

BA

CK

0

CANC

EL

INPUT

OUTPUT

TA

KE

R

Figure 2-5 — Mounting the MKP to the wall box

4

.

Reconnect the power supply and restore power.

Rear Panel and Side Panel Connections

All connectors are on the rear or side of the MKP (figure 2-6).
These connectors will be inaccessible once the MKP is installed.

Tx

HOST

RS-232

SWITCH

RS-232

Rx

GND

Tx

Rx

GND

12 VDC

LAN

PRESS T

A

B WITH

TWEEKER T

O

REMO

VE

GND

Tx

HOS

T

RS-

232

SWI

TCH

RS-

232

Rx

GND

Tx

Rx

GND

12 VDC

LAN

PRESS T

A

B WITH

TWEEKER T

O

REMO

V

E

GND

2

1

3

4

Figure 2-6 — MKP rear and side panels

1

LAN (Ethernet) port —

If desired, connect a Category (CAT) 5e

or higher (network) cable between this connector and
either the matrix switcher to be controlled or to an
Ethernet local area network (LAN).

See TP cable termination, on page 2-12, to properly wire
the RJ-45 connector for your application.

Ethernet connection indicators

The Link and Act LEDs

indicate the status of the Ethernet connection. The Link LED
indicates that the MKP is properly connected to an Ethernet
LAN. This LED should light steadily. The Act LED indicates
transmission of data packets on the RJ-45 connector. This LED
should flicker as the MKP communicates.

2

Host RS-232 port —

If desired, connect a host computer or

control system to this 3-pole, 3.5 mm, RS-232 connector
(figure 2-7).

Pin Function
TX
RX

Gnd

Transmit data
Receive data
Signal ground

Tx

HOST

RS-232

SWITCH

RS-232

Rx

GND

Tx

Rx

GND

Figure 2-7 — RS-232 connector

3

Switcher RS-232 port —

If desired, connect a cable between this

3-pole, 3.5 mm, RS-232 connector and a matrix switcher
(figure 2-7).

4

Power connector —

Plug the included external 12 VDC power

supply into this 2-pole captive screw connector. See Power
supply wiring
, on page 2-14 to wire the connector.

LAN

2-9

2-8

Advertising