Extron electronic MKP 2000 - Manual (Page 29)

MKP 2000 Remote Control Panel • HTML Operation MKP 2000 Remote Control Panel • HTML Operation
HTML Operation, cont’d
5-9 5-8
Authorized inputs and authorized outputs
You can use the Authorized Inputs and Authorized Outputs
drop boxes to narrow the number of inputs and outputs that are
controllable from the MKP.
When creating ties from the front panel, if an input or
output outside the available range for this MKP or the
connected matrix switcher is selected, the LED display
shows
N - A .
Front panel configuration lock
Click the appropriate radio button to select the Unlocked or
Locked to disable or enable the MKP control panel.
Date/Time Settings fields
The Date/Time Settings fields provide a location for viewing
and setting the time functions.
If setting the time, set the local time. The Zone variable
allows you to then enter the offset from Greenwich Mean
Time (GMT).
The Zone field identifies the standard time zone selected
and displays the amount of time, in hours and minutes,
that the local time varies from the GMT international
time reference.
When daylight savings time is turned on, the switcher
automatically updates its internal clock between
Standard Time and Daylight Savings Time in the spring
and fall on the date that the time change occurs in the
United States of America, Brazil, or Europe (depending
on the radio button selected). When Daylight Savings
Time is turned off, the switcher does not adjust its time
reference.
Port (RS-232) Settings Page
The Port Settings page (figure 5-4) allows you to configure the
MKP’s two (Host and Switch) RS-232 ports. Access the Port
Settings page by clicking the Configuration tab and then the Port
Settings link on the left side of the System Settings page.
System (IP)
Settings
Firmware
Upgrade
Passwords
Figure 5-4 — Port Settings page
The Serial Port 1 radio button selects the Host RS-232 port and
the Serial Port 2 radio button selects the Switch RS-232 port. All
changes made on the Port Settings must be confirmed by
clicking the Submit button. Clicking the Cancel button abandons
the changes.
The Extron defaults are shown below, but many switcher
models have configurable ports. Extron default RS-232 port
settings are:
• 9600 baud • no parity
• 8 data bits • 1 stop bit
• no flow control