AIRLESSCO SP200 - Manual (Page 20)

Shutdown and Cleaning
20 3A0994E
Power Flush
Power flushing is a faster method of flushing. It can only
be used after spraying water-based coatings.
1. Relieve pressure, page 10.
2. Remove tip and guard assembly from gun and place
in waste pail.
3. Place empty waste and
paint pails side by side.
4. Lift suction tube and prime tube from paint pail. Let
them drain into paint for a while.
5. Place suction and prime tube in waste pail.
6. Turn Pressure Control knob to the
Prime/Clean setting.
7. Screw power flush attachment to
garden hose. Close valve.
8. Turn on water. Open valve. Rinse
paint off suction tube, prime tube
and inlet screen.
9. Turn lever to close power flush
attachment.
10. Unscrew inlet screen from suction
tube. Place inlet screen in waste pail.
11. Connect garden hose to suction tube
with Power Flush attachment. Leave
prime tube in waste pail.
12. Turn power switch ON.
13. Open lever on Power Flush
attachment.
14. Circulate water through sprayer, into waste pail, for
20 seconds.
15. Turn power switch OFF.
ti9726a
ti9344a
ti9413a
ti9727a
ti2040a
ti2042a
ti5580a
OPEN
ti2043a
ti2018a