Airmar 200WX—Ultrasonic WeatherStation® Instrument - Manual (Page 8)

8
Cables & Connecting/Converting Hardware
The WeatherStation Instrument can be connected to a device and/or network in
several ways. You must have the correct cable and any needed converting/
connecting hardware before beginning the installation.
WeatherStation Cables Length Part No.
• NMEA 0183 Cable 10m 33-862-02
• NMEA 0183 Cable (WeatherStation with heater) 10m 33-1167-01
• NMEA 2000® Cable 6m 33-1029-02
• NMEA 2000® Cable 10m 33-1104-01
NOTE: Additional cable lengths are available.
Connecting/Converting Hardware Length Part No.
• NMEA 0183 to USB Data Converter 33-801-01
• NMEA 0183 to USB Combiner NDC-4-AIR
• NMEA 2000® CAN to USB U200 Gateway 33-727-01
• NMEA 0183 & NMEA 2000® Splitter 15m 33-632-01
• NMEA 0183 & NMEA 2000® Splitter 30m 33-632-02
Mounts
CAUTION: Vehicles/boats traveling above 30MPH—Do not use the plastic
Cable Side-exit Adaptor (part D) supplied. Purchase a stainless steel part. At high
speeds, the plastic adaptor may break, causing the WeatherStation Instrument to
fall off.
NOTE: The WeatherStation nut has standard 1"-14 UNS or 3/4" NPT threads.
Antenna mount with standard marine 1" -14 threads and pass-through for cable
(see Figure 1)
Hardware to install antenna mount
Extension tube (some installations)
Figure 1. Antenna mounts (not supplied)
extension
with cable
pass-through
ratchet mount deck mount
cable
passes
through
center
deck mount
of mount
cable
pass-
with extension tube center pass-through side pass-through
through
Copyright © 2007 Airmar Technology Corp.