Alinco DJ-C7 - Manual (Page 16)

16
4
Basic
O
perations
4.6 Memory Mode
This mode allows you to program frequencies into the DJ-C7
memory. A programmed frequency is called a channel.
The DJ-C7 has four types of memory functions; Memory
channel (general), Program scan channel, Priority channel, and
VFO auto programmed channel.
■Types of Memory
■Programming a Memory Channel
1. In the VFO mode, adjust the frequency you wish to
program by rotating the dial.
2. Set the Shift (+/-) and/or Split settings, if necessary.
For more information on these settings, please refer to "Shift /
Split Functions" on P.22.
3. Press the key to display a memory channel
number on the LCD, and select a channel you wish to
write to by rotating the dial.
The blank channels will blink and programmed channels will
remain lit up.
4. Press the key while the icon appears on the
LCD.
A beep sounds telling you that the frequency is written to the
memory channel successfully.
Tip
To overwrite to an already-existing memory channel, be
sure that the Memory Write Protect function is set to OFF.
For more information on this function, please refer to
"Memory Write Protect function" on P.26.
■Selecting a Memory Channel
1. Press the key to switch to the Memory mode.
A memory channel number will be displayed on the LCD.
Caution
When nothing is written to any memory channel, it can't be
switched to the Memory mode.
2. Rotate the dial to select the memory channel number
you wish to call up.
Clockwise rotation: Each click increases the memory
channel number by one.
Counter-clockwise rotation: Each click decreases the memory
channel number by one.
Memory channel
(general)
(0-199)
Program scan
channel
(0A, 0b-4A, 4b)
Priority channel
(PRI)
VFO auto
programmed
channel
(AH, AL)
This is a channel which is called up in the
Memory mode. You may program up to 200
channels in the DJ-C7. When you program
frequently used frequencies in advance, you
can easily select whatever you wish to use.
This is a channel which is used for the
Program scanning function. You can
program up to 5 pairs of frequency ranges
(higher and lower limits). (See on P.19)
This is a channel which is used for the
Priority monitoring function. (See on P.21)
This is a channel which is used for the
Repeater function. You can program a pair of
frequency ranges (higher and lower limit) to
apply settings for the repeater automatically.
Refer to "(3) Repeater function" on P.24 for
setting/operation detail.