Allmand Brothers TLB 535 - Manual (Page 29)

29
ƒ Clean the bucket by hand, if at all possible. If rapping the bucket against the stops is the only
option, then do so using MINIMUM force, to prevent cylinder damage.
ƒ DO NOT try removing stuck material from the bucket by striking it against the ground or
another object.
PREPARING TO OPERATE BACKHOE
1. Position loader bucket flat on the ground. Lower loader arms to raise wheels off the
ground.
2. Engage park brake.
3. Switch seats to position operator facing the backhoe.
4. Disconnect stabilizer locks and lower stabilizers to level unit.
5. Disengage swing lock and backhoe boom lock.
PREPARING TO OPERATE LOADER AFTER OPERATING BACKHOE
1. Retract backhoe bucket and dipperstick functions. Raise backhoe boom.
2. Center boom and engage boom lock and swing lock.
3. Raise stabilizers.
4. Engage stabilizer locks.
5. Switch seats to position operator facing the front end loader.
6. Roll back loader bucket until bottom is parallel with the ground.