Allmand Brothers TLB 535 User Manual
Page 9
9
Before changing seats to operate the backhoe:
Engage park brake.
Lower loader bucket to the ground.
After changing positions to the rear
backhoe seat:
Lower stabilizers to the ground.
Lift rear tires off the ground so as to
remove the weight from the tires.
Otherwise, from the loader operator
seat:
Raise loader bucket and stabilizers
Drive machine forward to change
position
Properly secure machine after each
move.
DO NOT dig under stabilizers!
Stabilizers must be set on firm
surfaces. Be alert to possible
machine movement when raising
stabilizers and loader bucket.
Avoid swinging bucket to the downhill side of the machine when digging on a slope.
Dump soil on the uphill side. If not, the machine has a possibility for rollover.
Move boom slowly when raising loaded bucket to full height.
Clear all persons from area of operation and machine movement.
HANDLE CHEMICAL PRODUCTS SAFELY
Direct exposure to hazardous chemicals can
cause serious injury. Potentially hazardous
chemicals used with Allmand TLB equipment
include such items as lubricants, coolants,
paints and adhesives.
A Material Safety Data Sheet (MSDS) pro-
vides specific details on chemical products,
physical and/or health hazards, safety proce-
dures and emergency response techniques.
Check the MSDS before you start any job
using a hazardous chemical.
Follow recommended procedures and only use
recommended and approved equipment.