Alps Spas XLS Models - Manual (Page 5)

alpsspas.com
A GOOD FOUNDATION
PLACING THE HOT TUB
Your new hot tub needs a good solid foundation. The area your hot tub sits on must be able to support the tub,
the water in it and those who use it. If the foundation is inadequate, it may shift or settle after the hot tub is in
place, causing stress to the shell or components.
BE AWARE:
Damage caused by inadequate or improper foundation support is not covered by the hot tub warranty. It is the
sole responsibility of the hot tub owner to provide a proper foundation for the hot tub.
Make sure the foundation where the hot tub is placed drains water away from the hot tub. Proper drainage will
keep components dry from rain and wet weather.
If you choose to install your hot tub indoors, pay close attention to the flooring beneath it. Always remember a
hot tub is filled with water. Choose flooring that will not be spoiled or ruined from water damage. Check with
your contractor to verify your flooring can support the weight and water spills or splashing from your hot tub.
Your hot tub weight must always be considered when installing your hot tub. If you are installing it on an
elevated wood deck or other structure, it is advisable to consult a structural engineer or contractor to ensure the
structure will support the weight.
IT IS STRONGLY RECOMMENDED THAT A QUALIFIED, LICENSED CONTRACTOR PREPARE THE
FOUNDATION FOR YOUR HOT TUB.
There is a 4” (10cm) minimum depth requirement for a concrete pad.
CHECK THE DIMENSIONS OF YOUR HOT TUB
Compare the hot tub dimensions to the width of gates, sidewalks, and doorways along the delivery route used
to bring the hot tub into your yard. It may be necessary for you to remove a gate or partially remove a fence in
order to provide an unobstructed passageway to the installation location.
Also, keep in mind—if you are using special equipment to place your hot tub into an area it will be necessary to
include those measurements and weights.
PLANNING A DELIVERY ROUTE:
Check the width of gates, doors and sidewalks to make sure your hot tub will pass through unobstructed. You
may have to remove a gate or part of a fence to allow for adequate width clearance.
If the delivery route will require a 90 degree turn, check the measurements at the turn to ensure the hot tub will
fit.
Check for protruding gas meters, water meters, A/C units, etc., on your home which will cause obstructions
along the delivery path to your yard.
Check for low roof eaves, over hanging branches or rain gutters that could be an obstruction to overhead
clearances.
SPECIAL CIRCUMSTANCES
The use of a crane for delivery and installation is primarily to avoid injury to your hot tub, your property or to
delivery personnel. Your dealer may be able to assist you with the arrangements. Cranes are not considered
“normal delivery” and would need to be a specialty request.
5