Feature operations – Alps Spas XLS Models User Manual
Page 9
alpsspas.com
FEATURE OPERATIONS
AIR CONTROL VALVE
Located around the top of the spa are air control valves. The air control valve serves to regulate the amount of
air mixed with the water when the jets are operational. Rotate the air control to “AIR” to achieve the maximum
jet pressure and therapeutic action. Rotating the air control to “OFF” turns the air off and allows the jets to work
with water only. Turn the air controls to “OFF” when the hot tub is not in use. This will prevent cold air from
entering the hot tub and will keep heating cost to a minimum.
HYDROTHERAPY JETS
The Hydrotherapy jets are recessed and located in the wall of the hot tub. Rotate the jet face clockwise to turn
the jets on, counterclockwise to turn the jets off. Not all jets have a rotational face to turn off and on the jets.
Turning off or on a jet will increase or decrease the effects of any jets “not” in the closed position.
LED MULTI COLOR LIGHT (when equipped)
If your hot tub is installed with a LED Multi Color light at factory, firmly and quickly turning the light switch on
and off will cause the light color effect to change to your desired program.
OZONATORS (when equipped)
If your hot tub is installed with an ozonator at the factory, your hot tub will automatically filter water at preset
times. Please note that ozonator and chemicals work together to kill bacteria. An ozonator cannot totally
eliminate the need for chlorine. Ozone is a bactericide. A tube links the ozone compartment with the ozone jet.
During the filter cycle, when the water pump is on low speed, the water movement through the ozone jet draws
the ozone out of the compartment, mixes with and purifies the water in the process.
WHIRLPOOL JET (when equipped)
Located below the water line at control panel, in the wall, is the whirlpool. This jet has a diverter valve and is a
high capacity jet, with a larger diameter than the hydrotherapy jets. Because there is a substantial amount of
water pressure when the jet is in operation, you must turn the pump off or to low speed before attempting to
rotate the diverter valve.
9