Aquatic AV AQ-MP-5BT-H - Manual (Page 6)

1.6 Installing the Media Player if an existing factory stereo is already installed
If replacing an existing Harley-Davidson ® factory stereo use the existing Harley-Davidson ® factory
side mounting brackets and hardware to mount the Media Player.
1. Unplug the 23-pin harness and FM/AM radio antenna from the factory stereo.
2. Remove the factory stereo and replace with the AQ-MP-5BT-H Media Player using the existing
factory mounting hardware.
3. Plug the 23-pin harness and FM/AM radio antenna into the AQ-MP-5BT-H factory stereo.
4. Turn the Media Player on to confirm operation (motorcycle ignition switch must be on) and
once correct operation is achieved turn the motorcycle ignition switch off before proceeding with
the final mounting of the chassis.
4. Ensure that the unit is supported and secured on the sides using the existing 4 factory screws;
failure to do so may allow the unit to move during while riding, causing damage to the mounting
area.
Getting Started
Media Player AQ-MP-5BT-H
6 www.aquaticav.com