ATL Telecom OM25 - Manual (Page 41)

41
ATL User Guide
OM25 O Optical M Modem
6
6.6.6 MONITORING
This screen is concerned with the monitoring mode of the master or slave units. This facility causes
system faults to be reported to a dumb terminal or printer whilst the operator is logged out.
Monitoring mode is a special mode that can operate when the user has logged off. It is designed
to connect to a printer or an unattended terminal. As alarms and faults are detected they are
printed on the screen (one line per fault). Over time a complete list of faults will be seen.
OM25 Thu 01 Jan 1970 00:52:52
Configuration > Monitoring
Urgent Alarm:On Non-Urgent Alarm:Off
Monitoring Mode
Report Faults [ ]
With Warning Bell [ ]
Press Return to Accept or Escape to Cancel
F1 Help F3 Previous Menu F4 Main Menu
Configuration Master/Slave
User Port
Master / slave configuration
Configure User Port
System
Subsystem Names
Monitoring
Reboot
Serial Communications
Front Panel
Allows you to reboot the system
Set date, time and menu timeout
Enter name, description and location of this unit.
Configures monitoring mode
Terminal set-up - baud rate, parity and handshake
Allows configuration of Front Panel controls