Epson DS500 - Manual (Page 16)

English
14
NOTE: The door contact sensor is not available in the DS505
Extended Run-Time Adapter. This sensor is used as a tamper
sensor when the battery door is opened.
TEMPERATURE SENSOR
The temperature sensor detects when the temperature rises above
or drops below the pre-set temperature threshold. The
MOBILELOCK
TM unit has both a high temperature sensor and a low
temperature sensor.
The temperature range is 0˚F–122˚F (-17 ˚C a 50 ˚C).The high
temperature sensor is not to be used for fire protection.
CAUTION: The temperature reading is approximate. The temper-
ature reading will be ignored at times when the MOBILELOCK
TM
unit is in a state known to change its internal temperature (battery
charging, etc).
After an alarm from the temperature sensor, the sensor is turned off
for 60 minutes. If the temperature of the environment still exceeds
the temperature range selected, another alarm will be sent. This
will continue until the MOBILELOCK
TM unit is disarmed.
MOTION DETECTOR
The motion detector is available in the DS510K combo kit. It detects
movement of heat sources in an enclosed area.
IMPORTANT: Once an alarm condition is signaled, further alarms
are inhibited until no motion is sensed for a period of more than
90 seconds. This feature is designed to conserve battery life by
ignoring the normal occurrence of motion throughout the day.
Assisted GPS Location
The MOBILELOCK TM unit can provide asset location via the phone
menu system or the MOBILELOCK TM website.
NOTE: The MOBILELOCK TM website and phone menu is subject
to change.
LOCATION VIA PHONE
1. Call 1-410-329-9477 and enter login and password.
2. Select
Locate from the main menu.
3. If you have more than one MOBILELOCK TM unit you will be
asked to select the correct one, the correct group or all.
4. After you verify that you have locates available, you will have
the option to record a location MOBILELOCK TM website or
speak with a customer service representative for assistance.
5. Wait for the phone menu to provide confirmation that the loca-
tion request has been sent. Do not hang up before this confir-
mation.
LOCATION VIA MOBILELOCK TM WEBSITE
1. Go online to www.dewalt.com/mobilelock and enter login and
password.
2. Select Unit Customization.
3. If you have more than one MOBILELOCK TM unit, you will be
asked to select the correct one, select a group, or select all.
4. Select Locate.
5. The amount of time to receive the location will vary. In most
cases, the location is provided in about one minute. Click
Location (view) to be linked to the map.
PAGING
If the location has been narrowed down to a single building, the
paging feature can assist in determining the exact location of the
MOBILELOCK
TM unit and the asset that it is protecting. The paging
feature works similar to finding a cordless telephone handset in the
house. Once activated, the paging will initiate a sound from the
MOBILELOCK
TM speaker. Walk around towards the noise to find
the MOBILELOCK TM unit.
TO INITIATE PAGING VIA PHONE
1. Call 1-410-329-9477 and enter login and password.
DS500 E,Sp 8/9/06 11:04 AM Page 14