Ensemble Designs BrightEye 55 Genlockable Sync Generator and Test Signal Generator - Manual (Page 8)

BrightEye 55 Genlockable SPG/TSG
BrightEye 55 - Page 8
For Unbalanced Audio to a RCA Phono Input – to connect the audio output to a
consumer audio connector such as an RCA phono jack, connect the pins as
follows:
• Attach Ground from Pin 1 of the Audio Out to the shell, Shield or Ground of
the RCA Phono jack.
• Attach the + (plus) signal from Pin 2 of the Audio Out to the center pin of
the RCA Phono jack.
• The – (minus) signal is not used in this application.
AES Out
The AES Out is a BNC connector that provides a digital audio output in the AES
format. The AES Output can be configured from the front panel and from the
BrightEye Control application.
HD Tri Level Sync Out
The HD Tri Level Sync Out is an output BNC connector that supplies HD
Tri Level Sync in a number of user selected formats. Either the front panel or the
BrightEye PC or Mac can be used to select the desired format. One of two
different TLS output frame rates can be selected in the BrightEye PC or Mac
Config menu (23.98/50/59.94 or 24/30/60).
SDI Out
The SDI Out is a BNC connector that provides test patterns or black in serial
digital component format. Test patterns and video standard can be selected from
the front panel as well as the BrightEye Control application. This output
conforms to the ITU-R 601 standard for serial digital video, with SMPTE 259M
serialization at 270 Mb/s. The AES audio test signals can be embedded in this
signal using BrightEye PC or Mac controls.
Cpst Out (Composite Out)
The Cpst Out is a BNC connector that presents either NTSC or PAL composite
output. This output provides the same test pattern as SDI Out, only in composite
format. The test pattern can be selected from the front panel and the BrightEye
Control application.
Ref In (Reference In)
The Ref In BNC will accept a PAL or NTSC reference input to provide an overall
genlock timing reference for the unit.