H3C Technologies H3C S12500 Series Switches - Manual (Page 12)

9
Figure 13 Removing the protective cover
NOTE:
Protective cover appearance varies with models. You can remove a protective cover of any model by
using the same way illustrated in this document.
2. Move the ejector levers on the front panel of the MPU outwards, hold up the MPU by one hand
without touching any electronic components on the MPU, and hold the front panel by the other
hand to push the MPU into the slot along the slide rails slowly.
3. Push the ejector levers inward to ensure close contact between the MPU and the backplane.
4. Position the screws into the holes and fasten them with a screwdriver to fix the MPU.