H3C Technologies H3C S10500 Series Switches - Manual (Page 21)

14
<EVB_bridge1> system-view
[EVB_bridge1] vlan 100
[EVB_bridge1-vlan100] quit
# Enable EVB on GigabitEthernet 1/0/1 that connects to EVB station 1, and configure
GigabitEthernet 1/0/1 to operate in trunk mode.
[EVB_bridge1] interface gigabitethernet 1/0/1
[EVB_bridge1-GigabitEthernet1/0/1] evb enable
[EVB_bridge1-GigabitEthernet1/0/1] port link-type trunk
[EVB_bridge1-GigabitEthernet1/0/1] quit
# Enable LLDP on EVB bridge 1 globally. Enable LLDP on GigabitEthernet 1/0/1, and configure
the Nearest non-TPMR Bridge agent for LLDP to operate in TxRx mode.
[EVB_bridge1] lldp global enable
[EVB_bridge1] interface gigabitethernet 1/0/1
[EVB_bridge1-GigabitEthernet1/0/1] lldp enable
[EVB_bridge1-GigabitEthernet1/0/1] lldp agent nearest-nontpmr admin-status txrx
[EVB_bridge1-GigabitEthernet1/0/1] quit
# Specify the IP address and port number for the default VSI manager on EVB bridge 1.
[EVB_bridge1] evb default-manager ip 192.168.1.1 port 8080
Configure other EVB bridges in the same way. (Details are not shown.)
2. Configure the EVB station:
Configure the EVB station on the VMM. For more information about configuring VMs through the
VMM, see the VMM manual. (Details are not shown.)
3. Configure the NMS:
Use VAN Connection Manager of IMC on the NMS to configure network resources.
The IMC PLAT 5.2 (E0401) and IMC CRM 5.2 (E0401) versions are used in this section.
Figure 4 VAN Connection Manager