H3C Technologies H3C SR6600-X - Manual (Page 122)

112
Item Remarks
Hot swapping Supported
NOTE:
•
For a combo interface, the default operating port is the copper port. You can use either the copper port
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
see H3C SR6600/SR6600-X Routers Interface Command Reference.
• Use transceiver modules for the fiber ports provided by H3C only. The router might be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-600 combo interface specifications
Specification of combo interfaces on the FIP-600 and the FIP-110 are the same. For more information,
see
Table 33 and Table 34 .
Transceiver modules for the FIP-600 and for the FIP-110 fiber ports are the same. For more information,
see Table 35 .
Maximum interface modules provided by FIP-600 in full configuration
FIP/Interface module SR6604-X SR6608-X SR6616-X
FIP-600 2 4 8
MIM Not supported Not supported Not supported
HIM 4 8 16
SAP-48GBE
SAP-48GBE front panel
Figure 102 SAP-48GBE front panel
(1) LEDs for GE ports 0 to 47 (2) SAP module status LED (RUN)
(3) GE ports 0 to 47 (4) Ejector lever
(5) Captive screw