H3C Technologies H3C SR6600-X - Manual (Page 68)

58
Figure 72 Pulling out the fan tray
4. Holding the handle of the fan tray with one hand and supporting the bottom of the fan tray with the
other hand, gently push the fan tray into the slot along the slide rails until it is completely seated.
5. Use a Phillips screwdriver to fasten the captive screws on the fan tray.
Replacing a fan tray for an SR6616-X router
1. Face the front of the router.
2. Press the fan tray release button with the thumb, slightly pull the fan tray away from the chassis,
and slowly pull the fan tray out along the slide rails when fans stop spinning.
3. Holding the front part of the fan tray with one hand, pressing down the release button with the
thumb, and supporting the bottom of the fan tray with the other hand, push the fan tray into the slot
along the slide rails until the fan tray makes complete contact with the backplane.