H3C Technologies H3C SecBlade FW Cards - Manual (Page 15)

8
Table 4 NAT address pool configuration items
Item Description
Index Specify the index of an address pool.
Start IP Address Specify the start IP address of the address pool.
End IP Address
Specify the end IP address of the address pool.
The end IP address must be identical to or higher than the start IP address.
Low priority
Configure the address pool as a low-priority or a non low-priority address pool.
IMPORTANT:
This configuration item is applicable to the stateful failover networking only. You cannot
configure the same address pool as the low-priority address pool on the local and peer
devices.
Return to Dynamic NAT configuration task list .
Configuring dynamic NAT
Select Firewall > NAT Policy > Dynamic NAT from the navigation tree to enter the page shown in Figure
4 . In the Dynamic NAT field where all dynamic NAT policies are displayed, click Add to enter the Add
Dynamic NAT page shown in Figure 6 .
Figure 6 Add Dynamic NAT page
Table 5 Dynamic NAT configuration items
Item Description
Interface Specify an interface on which dynamic NAT is to be enabled.
ACL
Specify an ACL for dynamic NAT.
You cannot associate an ACL with multiple NAT address pools, or associate an ACL
with both Easy IP and an address pool.