Grass Valley 8920MUX - Manual (Page 22)

22 8920MUX Instruction Manual
Configuration
The 8920MUX provides 18 configuration functions across two banks of the
rotary switch positions (shown in
Table 6 ). To make a configuration setting,
rotate the switch to the desired configuration parameter. The 16-position
rotary switch increments through 32 selection positions by addressing a
first and second bank of 16. When the switch is in the second bank, the 2nd
LED is illuminated. Move the paddle switch momentarily to either the up
or down position to make the desired selection
Refer also to Table 5 on page 20 for an over view of each of the parameters
and their default values.
Table 6. 8920MUX Configuration Functions
Function
Switch
Paddle
Switch Up
Paddle
Switch
Down
Function Description
Bank 1
0 -- -- Inactive position.
1 -- -- Not used.
2 Pass all -- Passes all audio channels to the outputs.
3 Auto-insert on Auto-insert off Automatic insertion of input AES/EBU audio into first available group.
4 Insert G1 Only
one
group
can be
inserted
-- Inserts the input audio group as G1 in the SD stream.
5 Insert G2 -- Inserts the input audio group as G2 in the SD stream.
6 Insert G3 -- Inserts the input audio group as G3 in the SD stream.
7 Insert G4 -- Inserts the input audio group as G4 in the SD stream.
8 Replace G1 Only
one
group
can be
replaced
-- Replaces the existing G1 audio group in the SD stream with the audio input to this module.
9 Replace G2 -- Replaces the existing G2 audio group in the SD stream with the audio input to this module.
A Replace G3 -- Replaces the existing G3 audio group in the SD stream with the audio input to this module.
B Replace G4 -- Replaces the existing G4 audio group in the SD stream with the audio input to this module.
C 20-bit 24-bit Select AES/EBU audio format.
D Sync Matrix --
Set to Sync Matrix when AES audio is in sync with SD video stream and status/control bits
are required. This configuration also allows switching of channel content in the audio group
using the GUI remote control interface.
E Sync AES Async AES
Set to Sync AES when AES audio is in sync with SD video stream and status/control bits are
required or set to Async AES when inputs not in sync and status/control bits are not
required.
F Recall factory defaults -- Recalls the initial factory setups. as given in Table 5 on page 20 .
Bank 2
0 -- -- Inactive position.
1 Delete all
Pass All
Removes all ancillary data from the SD stream.
2 Delete G1 Only
one
group
can be
deleted
Removes G1 AES/EBU group from the SD stream.
3 Delete G2 Removes G2 AES/EBU from the SD stream.
4 Delete G3 Removes G3 AES/EBU from the SD stream.
5 Delete G4 Removes G4 AES/EBU from the SD stream.
6 thru 9 -- -- Not used.
A thru E -- -- Not used.
F Recall
Save
(Down x 3 1 )
1 To Save current settings, the toggle switch must be held down for at least 3 seconds.
Recall previously saved user default configuration, or Save current configuration settings as
the user default.