Grass Valley 8920MUX - Manual (Page 23)

8920MUX Instruction Manual 23
Configuration
Remote Configuration and Monitoring
8920MUX configuration and monitoring can be performed using a web
browser GUI interface or a Newton Control Panel when the 8900NET
Network Interface module is present in the audio frame (Gecko 8900TFN-V
frame).
Note 8900NET module software must be version 3.2.0 or later.
This section describes the GUI access to the module configuration func-
tions. Refer to the Frame Status page shown in
Figure 9 .
Figure 9. 8900NET GUI
For Newton Control Panel control, refer to Newton Control Panel Configura-
tion on page 34 .
For remote access, make sure the jumper block on the module is set for both
Local and Remote access (
Figure 8 on page 21 ). Audio inputs must also be
specified as balanced or unbalanced with jumpers J1, J5, J7, and J8 as
described in
Setting On-Board Jumpers on page 8 .
8037_10
The Links section lists the frame and its current modules. The selected link's Status
page is first displayed and the sub-list of links for the selection is opened. The sub-list
allows you to select a particular information page for the selected device.
Content display section displays the information page
for the selected frame or module (frame slot icons are also
active links).
Online Manual Link
Refresh button for manual
update of page