Grass Valley 8943RDA - Manual (Page 62)

62 8943RDA/-D/-DFR — Instruction Manual
Configuration
Configuration
The 8943RDA-DFR can be configured using the front edge onboard con-
trols or using the remote controls available with a web browser or a net-
worked Newton Control Panel.
The Input Operating mode for all available inputs, Coax inputs J10 and J8,
and Fiber RX 1 input (with Dual Receiver SFP option installed) and Fiber
RX 2 (with Dual Receiver or Transceiver SFP option installed) must be con-
figured. All inputs can be active at the same time.
Each of the four possible input channels (Coax 10, Coax 8, Fiber RX 1, and
Fiber RX 2) can be assigned (mapped) to any one output pair or fiber output
as desired. The number of outputs depends on the type of SFP fiber optic
submodule installed. Outputs include Coax pairs J1/J2, J3/J4, J5/J6 and J7
(always active) and Fiber TX 1 (with Dual Transmitter or Transceiver option
installed) or Fiber TX 2 (with Dual Transmitter SFP option installed).
Note Fiber optic Tx1 and Tx2 outputs must be enabled by setting Jumper J13 on
the module circuit board. Refer to
Figure 15 on page 33 .
Local Configuration
For Local configuration, follow the summary of instructions given in Local
Onboard Configuration on page 33 for using the front edge onboard switches
for configuration.
Remote Configuration
Remote configuration methods are summarized in Remote Configuration on
page 38 .
For the 8943RDA-DFR module, each of the available web pages with and
without the SFP fiber optic options are shown on the following pages:
• Status ( page 63 )
• I/O Config ( page 68 )
• Settings ( page 73 )
• Slot Config ( page 78 )
Use
this
link