Grass Valley 8949MDA-CXF - Manual (Page 25)

8949MDA-CXF/-SXF — Instruction Manual 25
Power Up
Power Up
The onboard LED indicators are illustrated in Figure 14 . Upon power-up,
the green PWR LED should light and the CONFIG, FAULT and COMM
LEDs should illuminate during the module initialization.
Note When a module is first plugged into a GeckoFlex frame, the 8900NET module
(if present) may report a momentary fault. This will clear once the module has
booted up.
Operation Indicator LEDs
With a valid input signal connected, the Channel 1 PRES SIG LED EQ
(input to BNC J9), OPT 1, and/or OPT 2 (depends on presence and type of
fiber optic submodule) should be on. Refer to
Table 4 on page 26 to see a
complete list of possible operating conditions and the resulting indicator
status.
Note Channel 2 Monitoring Mode LEDs are not present or used at this time.
Figure 14. Front Module Indicator LED