Grass Valley 3-CCD ANALOG CameraMan Rev.B - Manual (Page 14)

Page 11 Connect Your 3-CCD Camera System
Restraining The Cable Connections
For upper (ie GEN LOCK) cable connections (if used)
1. Locate the cable restraint on the back left side of the camera.
2. Insert cable(s) through the cable restraint from left to right,.
Note: Allow 16” of cable between the restraint and the connection port to
provide enough slack for the camera’s tilting movement.
3. Tighten the restraint by pulling on the strap’s “free” end to prevent any cable from
becoming dislodged. (the cable restraint is reusable and adjustable)
4. Group the cables with all the other cables connected to the connector box and follow
the instructions below to feed them through the lower cable restraint.
For lower cable connections
1. Insert all cables (upper and lower) through the cable restraint from left to right.
This will result in the cables being located approximately in the center of the camera,
instead of near the edge.
2. Tighten the restraint by pulling on the strap’s “free” end to prevent any cable from
becoming dislodged.
Note: To relieve undue stress on the camera and the cable connections, it is
important to fasten all cables using the cable restrainer on the back of the
camera.
Note: Be sure to leave enough slack in the cables for the camera to pan left
and right free of any constraints.
Connecting The Power Supply
You can mount the Power Supply with any orientation, or on top of a table or roll-about unit
by using the following steps.
1. Verify that the POWER switch, on the back of the camera, is turned OFF.
2. Plug the 5.5mm female connector from the power supply cord into the DC POWER
jack in the back of the camera.
3. Connect the other end of the power supply into a 120 VAC source.
Feed the upper cables from left to right through the upper cable
restraint, then bundle with the lower cables and feed left to right
through the lower restraint.
Cable Restraint and System Power
You’ll notice that if left alone, the now connected cables may impede on the camera’s movement. To combat this, your 3-CCD
camera comes equipped with two cable restrainers on the left back, and on the connector box. Follow the instructions below to
properly restrain the cables and power-up the camera.
Power Connections and
Switches