Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 149)

Concerto — Installation and Service Manual 149
Field Replaceable Units
4. Insert and seat one new Controller module.
The PWR OK (power OK) and DONE LED will light signifying the new
module is up and ready to receive commands.
5. Press the reset switch on the redundant old Controller, causing control
to be handed off to the newly inserted Controller.
The next command sent from the control system will cause the ACT LED
to turn on. Continued commands will cause the ACT LED to flash.
6. Send and verify a switch command from the control system.
7. Remove the other old Controller module.
8. Insert and seat the other new Controller.
The PWR OK (power OK) and DONE LED will light signifying the new
module is up and ready to receive commands.
9. The next command sent from the control system will cause the ACT LED
to turn on.
10. Press reset on the Controller that is active to transfer control to the
second new Controller.
The next command sent from the control system will cause the ACT LED
to turn on. Continued commands prompt the ACT LED to flash.
11. Send and verify a switch command from the control system.
Jupiter Controlled Redundant Systems
1. Inspect the new Controller modules.
2. Set each of the 9 DIP switch settings and two rotary switch settings to
match that of the currently installed Controllers.
These can be viewed on the currently used modules while they are
active in the Concerto chassis. Note the status of the LEDs on the front
edge of the modules.