Grass Valley DEC-1023 - Manual (Page 9)

GUIDE TO INSTALLATION AND OPERATION
DEC-1023 | 5
3 Operation
3.1 Control options
The DEC-1023 can be controlled in three different ways:
• The local control panel and its push-buttons can be used to move through a menu of parameters and to
adjust parameter values (see section 3.3).
• Miranda’s RCP-100 remote control panel can be used to access the same menu structure from a remote
location (see section 3.4).
• Miranda’s iControl system can be used to access the card’s operating parameters from a remote
computer, using a convenient graphical user interface (GUI). (see section 3.5)
3.2 Card-Edge Status LED
The status monitor LED is located on the front card-edge of the DEC-1023, and is visible through the front
access door of the DENSITÉ frame. This multi-color LED indicates the status of the DEC-1023 by color, and
by flashing/steady illumination.
The chart shows how the various error conditions that can be flagged on the DEC-1023 affect the LED status.
• If a cell is gray, the error condition cannot cause the LED to assume that status
• If more than one LED status is possible for a particular error condition, the status is configurable.
See Section 3.5.15 for details.
• The factory default status is shown by a ›
• The error conditions that affect the LED status can be viewed on the Densité frame’s local control
panel. Push the Status button on the front of the card and see the error message displayed.
For example:
See section 3.3 for more information.
The LED will always show the most severe detected error status that it is configured to display, and in the
chart error severity increases from left to right, with green representing no error/disabled, and flashing red the
most severe error.
D E C - 1 0 2 3
C H 1 S I L E N C E