Grass Valley LGK-3901 User Manual
Page 121
GUIDE TO INSTALLATION AND OPERATION
LGK-3901/DSK-3901 | 115
Front Panel Menu Name
LGK
DSK
Description
KEYER ASSIGN
NONE
[4.11.2] Disables automatic keyer management
DSK 1
[4.11.2] Assigns DSK 1 for automatic keyer management
DSK 2
[4.11.2] Assigns DSK 2 for automatic keyer management
DSK 3
[4.11.2] Assigns DSK 3 for automatic keyer management
DSK 4
[4.11.2] Assigns DSK 4 for automatic keyer management
DSK 5
[4.11.2] Assigns DSK 5 for automatic keyer management
KEYER RELEASE
DISABLED
[4.11.2] Leaves the assigned keyer cut up when all Graphics Co-
Processor keyers are cut down
ENABLED
[4.11.2] Cuts down the assigned keyer when all Graphics Co-Processor
keyers are cut down
KEYER STATUS
KEYER STATUS
[4.11.2] Displays Co-Processor layers for automatic keyer management
FILL&KEY INPUT
FILL-1/KEY-1
[4.11.2] Routes Fill-1/Key-1 inputs to the assigned keyer during
automatic keyer management.
FILL-2/KEY-2
[4.11.2] Routes Fill-2/Key-2 inputs to the assigned keyer during
automatic keyer management.
MISCELLANEOUS
CLOSED CAP
DISABLED
[4.12] Allows keyed graphics to overwrite Closed Caption information in
the active picture for NTSC
ENABLED
[4.12] Preserves Closed Caption information in active picture for NTSC
SEND WAKEUP
Sends a wake up packet to all connections
FILE OPS
ERASE IMAGE
Erases an image from disk storage
ERASE AUDIO
ACTIVE PREVIEW
DISABLED
[4.9.3] Switches off active preview mode for Xpanel and iControl
ENABLED
[4.9.3] Switches on active preview mode for Xpanel and iControl
SELF TESTS
DSK 1
IMAGE BORDER
Displays a test pattern showing 4-pixel width colored borders
ANIMATION FILL
Shows a continuously repeating progress bar
DSK 2
IMAGE BORDER
See “DSK 1” above
ANIMATION FILL
See “DSK 1” above
DSK 3
IMAGE BORDER
See “DSK 1” above
ANIMATION FILL
See “DSK 1” above
DSK 4
IMAGE BORDER
See “DSK 1” above
ANIMATION FILL
See “DSK 1” above
DSK 5
IMAGE BORDER
See “DSK 1” above
ANIMATION FILL
See “DSK 1” above
PROD TESTS
Enters Production Mode in which all functions of the card halt
SOFT RESTART
Causes the software to restart
HARD RESTART
Causes the hardware to reboot
FACTORY RESET
Resets the unit to the factory default configuration
SAFE SHUTDOWN
Prepares the unit to be powered off
TEST
TEST PATTERN
OFF
Switches off the test pattern signal for PGM OUT and PVW OUT