Grass Valley K2 Edge Installation v.4.0.2 - Manual (Page 31)

K2 Edge Installation and Service Manual - document version: 4.0.2 – Page 31
13.4 Replacing a redundant power supply module
CAUTION: To avoid electrostatic discharge, make sure that you are properly grounded.
You do not have to halt or power off the K2 Edge when replacing a single power supply.
Hard disks are hot swappable and redundant.
WARNING: Any instructions in this manual that require opening the equipment cover or
enclosure are for use by qualified service personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
To replace a power supply:
 Open the front panel.
 Pull the level to the left and keep in this position while pulling the power supply forward to
remove from the server.
 Slide the replacing power supply in its bay and close the front panel.