Grass Valley HD Wireless - Manual (Page 56)

56 HD Wireless User’s Guide (v6.2)
Chapter 5 - Menu contents
5.2.3 WCU Audio/Intercom menu
Cam number On, Off Displays the camera number in the status
bar Oper -
Menu item Values Description Level File
Menu item Values Description Level File
Audio
Delay On. Off Switches audio delay on or off.
On: a delay is added to the Audio down link
signal which compensates for the Video
delay. Install -
Audio Out1 Level 0dB, +6dB Selects audio 1 output level Install -
Audio Out2 Level 0dB, +6dB Selects audio 2 output level Install -
Mode Single, Dual Dual: Audio channels 1&2 are used.
Single: Only Audio channel 1 is used in the
WCA. Audio Channel 1 is duplicated on
Audio Channel 2 as well.
Note: this menu is the same as the camera
system menu INSTALL > AUDIO > AUDIO
IP MODE. Install -
InterCom
Eng
Wire Mode 2wires, 4wires Selects studio intercom wiring mode for
Engineering channel Install -
2w_Balance 0..99 (50) Sets 2-wire intercom balance Install -
Level 0dBu, +6dBu Selects intercom channel input level Install -
Out Ref Level 0..99 (50) Sets output reference level Install -
Prod
Wire Mode 2wires, 4wires Selects studio intercom wiring mode for
Production channel Install -
2w_Balance 0..99 (50) Set 2-wire intercom balance Install -
Level 0dBu, +6dBu Selects intercom channel input level Install -
Out Ref Level 0..99 (50) Selects output reference level Install -
Prog
Level 0dBu, +6dBu Selects intercom channel input level Install -
Isolate Isolate, System Isolate = isolate Prog and Prod intercom
channels from Eng,
System = isolate Off Install -
1kHz Tone On, Off Switches test tone on or off Install -
Compander On, Off Switches compander on or off Install -