Other settings – Grass Valley Ignite SDC User Manual
Page 55
Ignite SDC/HDC Robotic Camera Instruction Manual
55
Menu Selections
Other Settings
Figure 29. Other Settings Submenu
YI Phase
Varies the hue of the yellow.
YI_G Gain
Increases or decreases the intermediate color between yellow and green.
YI_G Phase
Varies the hue of the intermediate color between yellow and green.
G Gain
Increases or decreases the green.
G Phase
Varies the hue of the green.
G_Cy Gain
Increases or decreases the intermediate color between green and cyan.
G_Cy Phase
Varies the hue of the intermediate color between green and cyan.
Cy Gain
Increases or decreases the cyan.
Cy Phase
Varies the hue of the cyan.
Cy_B Gain
Increases or decreases the intermediate color between cyan and blue.
Cy_B Phase
Varies the hue of the intermediate color between cyan and blue.
B Gain
Increase or decreases the intermediate color between blue and magenta.
B Phase
Varies the hue of the intermediate color between blue and magenta.
Table 14. Other Settings
Selection
Description
Gamma
(0.35 to 0.55) Gamma correction level can be set.
Knee Point
88% to 98%: The level of video signals subject to knee (knee point) can be
set. Dynamic: Knee level is automatically adjusted according to the scene.
White Clip
(95% to 110%) The peak level of video signals to be white-clipped can be
set.
Flare R/G/B
(0 to 100) Flare correction level can be adjusted.
Black Stretch
Black stretch to correct the suppression of black portions at low luminance
can be set to ON or OFF.
Clean DNR
(OFF, Low, High) This enables the clean DNR effect to be selected.
Field/Frame
Field: CCD storage will be by field storage.
Frame 1: Vertical resolution increases in frame storage.
Frame 2: Vertical resolution is raised without increasing residual images
by frame storage and electronic shutter.
Baud Rate
(1200bps, 2400bps, 4800bps, 9600bps) This setting is to select a com-
munication speed in controlling the camera from the computer.
Component
This enables RGB, Y/Pr/Pb or Y/C to be selected as the component signals
which are to be output from the I/F REMOTE connector.
Table 13. Color matrix Settings
Selection
Description
8492_19_r0