Grass Valley Ignite SDC - Manual (Page 72)

72 Ignite SDC/HDC Robotic Camera Instruction Manual
Appendix B — SD (PAL) Camera Block
G/L Adjustment Settings
Figure 43. G/L Adjustment Setting Submenu
Detail Settings
Figure 44. Detail Setting Submenu
Table 26. G/L Adjustment Settings
Selection Description
H Phase
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
SC Coarse
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
SC Fine
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
Table 27. Detail Settings
Selection Description
Detail
(OFF, Low, High) Contour correction quantity can be selected. Detail set-
tings made using the Horizontal/Vertical Detail Level High/Low setting.
Detail level can be set in horizontal (H) and vertical (V) directions with the
Detail setting at High or Low.
Whichever the direction, H or V, the set level at High must be at least one
position higher than that
at Low.
H Detail Level H (L+1 to +63)
V Detail Level H (L+1 to +31)
H Detail Level L (1 to H-1)
V Detail Level L (1 to H-1)
8492_35_r0
8492_36_r0