Grass Valley NV9601 v.2.2 - Manual (Page 30)

20
Configuration
Panel Options
Checkbox Options
The checkbox options section is at the bottom of the panel options section:
A check in the box enables the option. Clearing the checkbox disables the option.
By default, all the check box options are clear except ‘Use Continuous Scrolling’. That particular
option is enabled by default.
The following items are the checkbox options:
• User-Programmable ID.
Allows the Panel ID to be changed locally at the control panel (in menu mode).
• Save Preset Default.
Makes ‘Save Preset’ mode active when the panel reverts to its default state (after a Default
State button is pressed, or when the panel is restarted).
 A ‘Save Preset’ button is needed only when you want the operator to be able to view or
change the mode.
• Hold Preset Default.
Makes “hold” mode active when the panel reverts to its default state (after a Default State
button is pressed, or when the panel is restarted).
 Note: a ‘Hold’ button is needed only when you want the operator to be able to view or
change the mode.
• Enable Source Lock.
Check ‘Enable Source Lock’ to allow the panel operator to lock sources.
Default Name
Set System Name A list of “name sets” appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose ‘System Name’ in this list if you do not
want, or do not care about, device name aliases. Do not choose
‘System Name’ if you are configuring any ‘Name Set Toggle’ but-
tons.
Multidest
Device Limit (Selectable in
multiples of 8) The number of multi-destination entries you are defining. (Strictly
speaking, this is not a limit, but a count.) The default, and lowest
value, is 8. The maximum is 512. (If you have more entries than
devices, you can leave some MD destinations unassigned.)
(If the configuration has 8 MD destinations, MD scrolling is dis-
abled.)