Grass Valley PDR100 - Manual (Page 79)

Electrical Characteristics
PDR100 Installation A-7
Table A-8. Component Analog Video Performance
Characteristic Specification
A to D conversion: Supplemental Data:10 bits at 27 MSPS on all 3 inputs
Output video data: Supplemental Data:Dynamically rounded (dithered) to 8 bits
Input gain controls: Requirement: Each CAV input is software adjustable
±
3dB except
MII, which is software adjustable +2.5/-3dB.
Input Setup Controls Requirement:
±
20 mV
Supplemental Data:Software adjustable
Frequency response: Requirement: (Y)
±
0.25 dB 0-5.8MHz
(Cb/Cr)
±
0.25 dB 0-2.75 MHz
Signal-to-Noise Ratio Requirement: > +50dB
Relative timing error: Engineering Note: Y to Cb/Cr, <5ns by design
Cb to Cr, <5ns by design
Measurement accuracy
±
5ns
Internal Sync (Y/G input)
timing: Requirement: Digital video output H position error <25ns w.r.t. input
sync
Engineering Note: CAV auto-timing ON. Input signal timed to Genlock
Black Burst.
Standards selection: Software selectable 525/625
Gain Accuracy Requirement: All supported input formats translated to
±
1% of
SMPTE/EBU-N10 levels given in Tables A-9 and A-10
Supplemental Data:75% bars with 100% flag
K Factor K-2T (Y)
K-4T (B-Y)
K-4T (R-Y)
Requirement:
≤
1%
Supplemental Data:Component K factor measurement @ VM700
K Pulse-to-Bar Requirement:
±
1% K factor
Supplemental Data:Component K factor measurement @ VM700
Table A-9. Format Voltage Level Definitions for CAVmtrxN Colorbar Matrix Test Clip
Format White Yellow Cyan Green Magenta Red Blue Black
SMPTE/EBU-N10
(MII w/o setup)
Y 700 465.2 368 308.2 216.8 157.0 59.9 0
B-Y 0 -262.5 88.6 -173.9 173.9 -88.6 262.5 0
R-Y 0 42.7 -262.5 -219.8 219.8 262.5 -42.7 0
MII
Y 700 482.8 392.9 337.6 253.1 197.7 107.9 52.5
B-Y 0 -242.8 81.9 -160.9 160.9 -81.9 242.8 0
R-Y 0 39.5 -242.8 -203.3 203.3 242.8 -39.5 0