Grass Valley TTN-CP-UNI - Manual (Page 15)

CP-UNI Rev. 2
7
5 Control panel configuration
5.1 Pre-set default level
The second Dip-switch Block from the left, SW2 (8 user switches):
At power-up the panel will do a presence check for routers on the pre-set default level. The pre-set
default level can be defined on configuration switch A (leftmost).
Please set the pre-set default level to the address of the routing system you would like to start working
with after powering up CP-UNI
Switches 1 – 3 (from left) on the configuration switch set the control panels level for communication with
the other units in the NCB system. The panels on the NCB dedicated to operate with a specific router
have to be configured to the same level.
Note that although the Triton routers may be configured up to 16 levels, the Triton control panels may
only be configured up to 8 levels. Levels 9 – 16 must be controlled by either Triton - Router Control
System, or by any third party router control system.
The levels can be switched according to the following pattern:
- means switch OFF (down)
* means switch ON (up)
Default level is 1.
Switch 1 2 3 Level
- - -
1
- - * 2
- * - 3
- * * 4
* - - 5
* - * 6
* * - 7
* * * 8
Switch 4 is not in use for this product.
The Dip-switch Blocks, SW1 (8 user switches), and SW3 (4 user switches) are not in use.