Grass Valley XSwitch Feb 08 2006 - Manual (Page 23)

XSWITCH Installation and Operation Manual 23
Connecting XSWITCH and the Ignite System
Figure 10. Expansion Address Card Jumpers
If a second Expansion Frame is employed, a second cable connects it to the
first Expansion Frame at either side of the dual 50-pin connector on the
Expansion Card in the each Expansion Frame. Also, be sure the Address
Card jumper is set for Address 2 (
Figure 10 ).
If a third Expansion Frame is employed, the pattern is repeated using a
third cable connected between the second and third Expansion Frame.
Also, be sure the Address Card jumper is set for Address 2 (
Figure 10 ).
Expansion Card1
Address Jumper 1
Expansion Card 2
Address Jumper 2
Expansion Card 3
Address Jumper 3
Expansion
Connector