Polaris 2004 Victory Vegas - Manual (Page 138)

136
CLEANING
Washing and Drying the Motorcycle
Use as little water as possible when washing near the air cleaner or the exhaust pipe openings. An
excessively wet air cleaner, or water in the exhaust pipes, may cause the engine to start and run poorly.
Dry these components thoroughly before using the motorcycle.
Caution
5. Clean the front fork tubes thoroughly to reduce fork seal wear and leakage.
6. If insects, oil, tar, tree sap, or other foreign material is difficult to remove by applying gentle pressure using the
warm water and mild detergent mixture, you may need to use a special cleaner. Choose a cleaner designed for
use on the type of surface you plan to clean.
7. Rinse the motorcycle with water running at low pressure.
8. Remove the rubber bands and plastic bags from the exhaust pipes, and wipe the motorcycle dry with a soft cloth
or chamois.
9. After washing the motorcycle, start the engine and let it idle for a few minutes. Make sure the brakes are
functioning properly before riding.
Excessively wet brake pads or discs may diminish braking effectiveness. Dry these components
thoroughly before using the motorcycle.
WARNING