Polaris 2003 Frontier - Manual (Page 114)

112
MAINTENANCE
Steering System
Ski Skags
Check skags weekly to maintain positive steering characteristics. Skags
must be replaced when worn to half their original diameter.
NOTE: Carbide skags must be replaced if any abnormal wear or
chipping is found.
Skag Replacement
1. Raise and support the front of the machine so the skis are
approximately 6″ (15.2 cm) from the ground.
2. Remove the attaching nuts and pry the skag (A) downward.
3. Remove the forward portion of the skag first, then remove the
entire skag.
Reverse this procedure for new skag installation.
Worn skis and/or skags will adversely affect handling. Loss of
vehicle control may result, causing serious injury or death.
See your dealer’s studding chart for recommended skags. If you
install longer or more aggressive carbide skags than the original
equipment, it may also be necessary to add track studs to maintain
proper vehicle control while turning on hard-packed snow or ice.
WARNING
A