Polaris 2003 Universal Snowmobiles - Manual (Page 103)

101
OPERATION
Reverse Operation (Electronic)
This reverse will only activate if the engine is below 4000 RPM. Make
sure the vehicle is stopped and the engine is running at idle.
1. Make sure the area behind you is clear.
2. Push the yellow reverse button on the left hand control for one second
and release. The engine will automatically reduce RPM and start a
reverse rotation. A flashing reverse light on the instrument panel will
indicate the machine is in reverse.
NOTE: If your machine is running at an altitude of over 6000 feet, it
will be necessary to adjust the ignition setting as described on page 102.
3. Slowly apply the throttle until movement starts and until you are
certain you are in reverse.
NOTE: The maximum engine RPM will be 6000 when in reverse.
NOTE: If the engine has stopped running, the snowmobile will run
forward the next time it’s started.
Reverse operation, even at low speeds, may cause loss of control,
resulting in serious injury or death. To avoid loss of control, always:
S Look behind before and while backing.
S Avoid sharp turns.
S Shift to or from reverse only when stopped.
S Apply throttle slowly.
WARNING
To avoid personal injury and/or engine damage, do not operate
the electric starter or pull-rope starter while the engine is
running.
CAUTION