Polaris 2013 BRUTUS Accessory Mower - Manual (Page 26)

25
OPERATION
Removal
Removing The Mower
Tip: In muddy conditions or to prevent the attachment from freezing to the ground, put the attachment on planks or blocks before removing
the attachment from the machine.
WARNING!
AVOID INJURY OR DEATH
Before leaving the operator seat:
• Park on flat level ground
.
• Lower the attachment arm, put the attachment flat on the ground .
• Press the brake and put the gear selector lever in PARK .
• Stop the engine and remove the key .
• Make sure PTO driveline and all rotating parts have come to a complete stop.
SEE THE BRUTUS OWNER’S MANUAL FOR MORE INFORMATION.
1. Always park on flat level ground. Fully lower the attachment
arm and put the attachment flat on the ground.
2. Stop the engine.
3. Exit the utility vehicle. See page 16.
4. Disconnect the PTO driveline. See page 22.
5. Enter the utility vehicle. See page 16.
6. Start the engine.
7. With the gear selector lever in PARK, raise the mower until it
is slightly off the ground.
8. Stop the engine and exit the utility vehicle. See page 16.
9. Remove the retaining pins (Item 1) (both sides).
10. Remove the pins (Item 2) (both sides).
11. Install the two pins (Item 3) and retaining pins (Item 4) in the
storage location on the mounting frame.
1
2
3
3
4
4