Pre-ride inspections – Polaris 2015 Slingshot User Manual

Page 39

Advertising
background image

37

PRE-RIDE INSPECTIONS

Turn the ignition key to the ON position before performing the electrical pre-ride
inspections. Return the ignition key to the OFF position after completing these inspections.
If inspection of any electrical item reveals component failure, repair or replace the
component before operating the vehicle.

Item

Inspection Procedure

See

Page

Electrical

Front Lights

Turn the ignition key on. Verify that the headlights, auxiliary lights (if
equipped) and park lamps illuminate. Switch to high beam. Verify that
the high beam indicator comes on and that headlamp brightness
increases. Adjust headlight aim as needed.

74

Rear Lights

Verify that the taillights and license plate light illuminate. Apply the
brakes and verify that the taillight lamps increase in brightness.

-

Turn Signals

Verify that the left and right turn signals flash at the front and rear of the
vehicle, and that the corresponding indicator lamp flashes in the gauge.

-

Emergency
Flashers

Press the top of the hazard switch to turn the flashers on. Verify that all
four turn signals flash, as well as the lamps in the gauge. Press the
bottom of the switch to turn the flashers off. Verify that all signals and
indicator lamps stop flashing.

-

Horn

Press the horn button. Verify that the horn sounds loudly.

-

Low Oil Pressure
Indicator

Start the engine and verify that the low oil pressure lamp does not
illuminate.

-

Steering

Check power steering for smooth operation.

38

General

Engine Oil Level

Check the oil level.

52

Fuel Level

View the fuel gauge to check the fuel level.

38

Coolant Level

Check the recovery bottle coolant level.

56

Tires

Inspect tire condition, pressure and tread depth.

65

Wheels

Inspect for loose, damaged or missing wheel nuts.

66

Brake Fluid Level

Check the master cylinder brake fluid level.

63

Park Brake

Verify that the vehicle does not roll when the park brake is set.

29

Brake System

Inspect brake system hoses, connections and brake pads. Check brake
pedal for excessive travel or a spongy feel.

64

Throttle Pedal

Check throttle pedal travel, ensure smooth operation and full return.

27

Clutch System

Check fluid level and pedal travel.

60-61

Front Suspension

Check for suspension wear or damage.

38

Rear Suspension

Check for suspension wear or damage.

38

Drive Belt

Check for wear or damage.

38,58

Fasteners

Inspect entire vehicle for loose, damaged or missing fasteners.

38

Mirrors

Adjust for proper side and rear view.

-

Advertising
This manual is related to the following products: